Products from Jantzen Audio

No results were found for the filter!
NON-STOCK ITEM! ETD 10-14 days Rdc 0.18 Ohm Iron Cored with discs, baked, perfect layer Tolerance: +/- 3% D*H (mm): D 36 * H 46 High-purity copper wire wound around a Permite core, for a high inductance at the lowest cost. Extremely low...
€13.12 *
1.30 mH 14 AWG CrossCoil Rdc 0.300 Ohm 14 AWG = 2.10 mm2 Power handling 500 Watts RMS Tolerance: +/- 3% H*D (mm): H 37.0 * D 74.0 The Cross Coil has been developed in cooperation with Audio Technology, Denmark, producing high-end drivers...
€51.04 *
Jantzen Audio Cross Cap 2.40uF 400Vdc High quality and affordable entry level PP capacitor Made from high quality foil, produced and metalized in the EU This capacitor is virtually distortion free and has a neutral sound profile Multi...
€1.45 *
Jantzen Audio Cross Cap 4.10uF 400Vdc High quality and affordable entry level PP capacitor Made from high quality foil, produced and metalized in the EU This capacitor is virtually distortion free and has a neutral sound profile Multi...
€2.15 *
Jantzen Audio Cross Cap 5.10uF 400Vdc High quality and affordable entry level PP capacitor Made from high quality foil, produced and metalized in the EU This capacitor is virtually distortion free and has a neutral sound profile Multi...
€2.75 *
2 pole terminal plate Looking for a higher-performance alternative to standard terminal cups? The binding post plates are the answer. Made from 3mm aluminum. A pre-installed gasket and beveled outside edge allow easy installation without...
€9.99 *
2 pole terminal plate anodized Looking for a higher-performance alternative to standard terminal cups? The binding post plates are the answer. Made from 3mm anodized aluminum. A pre-installed gasket and beveled outside edge allow easy...
€15.95 *
Jantzen Audio JA-8008HMQ woofer 8Ω The Jantzen Audio JA-8008 HMQ™ is a very special 8” paper cone midwoofer, designed by Danish loudspeaker designer Troels Gravesen. Manufactured exclusively for Jantzen Audio by SEAS in Norway. A very...
€240.00 *
Jantzen Audio Alumen Z-Cap 0.47uF 100Vdc The Alumen Z-Cap was especially designed for the tweeter and mid-section of crossovers for passive hi-fi speakers. The improved transparency performance of this new cap is on the same high level...
€28.50 *
Jantzen Audio Alumen Z-Cap 0.56uF 100Vdc The Alumen Z-Cap was especially designed for the tweeter and mid-section of crossovers for passive hi-fi speakers. The improved transparency performance of this new cap is on the same high level...
€30.50 *
Jantzen Audio Alumen Z-Cap 0.68uF 100Vdc The Alumen Z-Cap was especially designed for the tweeter and mid-section of crossovers for passive hi-fi speakers. The improved transparency performance of this new cap is on the same high level...
€32.50 *
Jantzen Audio Alumen Z-Cap 0.82uF 100Vdc The Alumen Z-Cap was especially designed for the tweeter and mid-section of crossovers for passive hi-fi speakers. The improved transparency performance of this new cap is on the same high level...
€34.25 *
Viewed